:link: My profile link : Anthony Homan - CityStrides Yesterday I finished Mountain Boulevard in Oakland: Mountain Boulevard - CityStrides But it shows as “progressed” on the day’s activity . When I go to the street detail page it says 100% up top and I can’t see any incomplete nodes. I was hoping it…

Ah, I see … the street thinks it has 577 nodes when it really has 558. I re-counted all the streets in Oakland, just in case. Then I ran the percentage code for your account & it added the one street. So you should be all set now.

James, I’m getting the same issue in Lomita, California . This street: Via Desmonde - CityStrides is showing as me having completed it 100%, but it’s coming up as incomplete anyway. It looks like it thinks there are 10 nodes when I only count 9 on the map. Edit to add my profile: Robb B. - CityStrid…

I don’t know if you did anything in the past 10 minutes, but it’s suddenly showing up as complete…. so nevermind.

Sorry for the confusion here - sometimes I have time to fix an issue but not to reply in the forum :sweat_smile:

No worries, thanks for all the hard work you do!

I have an issue that some completed streets are not counted. The problem seems to be that these streets go over the community border and have the same name in both communities. In most cases they are counted as completed in only one of the two communities. Here is one example, if necessary I can pr…

Yeah, there was a bug in older city sync code that could leave streets with incorrect node counts … That would cause 100% to be impossible to reach. I reset the node counts for all the streets in Ottobrunn, then reprocessed your account. So you should be all set now.

Wow, thanks a lot! The speed of your support is really superb! :smiling_face_with_three_hearts: Would it be too insolent to ask if you could do that for our neighbors in Neubiberg as well? I have at least two streets on their side which were not counted as well. Probably as a side effect I just g…

Regarding my comment about Landsberger Straße, I found out the reason: This area wasn’t in hard mode modus even I had set it globally before Walking there. So I turned hard mode off and on as described in the other thread and now it’s fine.

The CityStrides Community

100% completed street not showing as Complete

Support

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled