I got to walk in Philadelphia this week and wore my Garmin so that I could add Philly to the list of cities on my profile. Less than a mile, no completed streets. But Philly doesn’t show up in my city list, even after completing a couple of run outings since then. Same is true for Lansdale, PA, even after completing a few streets over a few miles. Several other cities are in my list even though I haven’t completed any streets in them.
What’s the minimum to run in a city before it shows on your list? Or the minimum number of completed streets? Or should a city show up as soon as you have any distance on one of its streets?
That is a new development. On Wednesday it was not there, even with some mileage there previously. Maybe I crossed the magic threshold with this morning’s run.
It says you completed these six streets today Sep 12 at a run 5.53 am. Time zone issue? But sometimes it can take hours from a run is done until it’s seen in CS.
And supposedly only cities with at least one finished street will be in your city list. For some reason I can also see some cities with no completed streets in my list, but that’s not intended to be so. This was mentioned in a discussion quite recently, but I can’t locate it now.
You must complete one street before it shows up on your list
I don’t do city cleanup in the city update process, so it’s possible to complete a street in a city (adding it to your list) and then have a city update remove that completed street but leave the city in place.
I’d like to go back and add that cleanup, but things keep coming up.
Thank y’all for the assistance. Yes I think my previous runs in. Lansdale did not complete any streets, even though they were probably a couple of miles in there. I appreciate the help very much!